BoatBuilding Cutting the Frames

BoatBuilding - Cutting the Frames
Originally uploaded by OzzyC.

Over the last couple of weeks, weve been constructing temporary frame pieces, which were cutting out of particle board. The reason were doing this, and the process behind what were doing will take a little bit of explaination, so be prepared for a long entry.

The reason were cutting these temporary frame pieces is so that were sure the hull is straight. If you look at the picture, you may notice two pieces of board... one smaller piece of board, sitting on top of the particle board. The smaller piece is the actual frame piece that will be in the boat when its put on the water. The hull goes much farther up than this though, so we are using temporary pieces during the hull setting process. Once the hull is set, we will remove the temporary pieces and install the permanent pieces, so that we can add the deck.

In order to cut these sacrificial particle board frame pieces, we started with a 4x8 piece of particle board. We set the actual frame piece on the particle board and clamped it in place. We then determined the center point and line of the actual frame piece and extended this center line through the particle board, so that we could measure needed dimensions. After measuring the center line, we extended the end-lines of the permanent frame piece up the particle board, and measured from the center line to the top corners. In order to make sure our cuts were true, we measured cross-angle. we then added the notches and cut it all out with a power saw, except for the notches, where we used a jigsaw.

Click here to see the video summary of what we did.

Related Posts by Categories